Materiales
Materiales
ISO 4097:2020 - Rubber, ethylene-propylene-diene (EPDM) — Evaluation procedure
01/08/2020 -
This document specifies:— the physical and chemical tests on raw rubbers;— the standard materials, standard test formulations, equipment, and processing...
D7465/D7465M Standard Specification for Ethylene Propylene Diene Terpolymer (EPDM) Sheet Used In Geomembrane Applications has been reapproved, available as D7465/D7465M-15(2019)
-
1. Scope 1.1 This specification covers flexible sheet made from ethylene propylene diene terpolymer (EPDM) geomembrane intended for use in geotechnical and...
D3568 Standard Test Methods for Rubber#x2014;Evaluation of EPDM (Ethylene Propylene Diene Terpolymers) Including Mixtures With Oil has been reapproved, available as D3568-03(2018)
-
Significance and Use 3.1 These test methods are intended mainly for referee purposes but may be used for quality control of rubber production. They may also be used in...
D6047 Standard Test Methods for Rubber, Raw#x2014;Determination of 5-Ethylidenenorbornene (ENB) or Dicyclopentadiene (DCPD) in Ethylene-Propylene-Diene (EPDM) Terpolymers has been revised to D6047-17
-
Abstract These test methods cover the determination of the content of 5-ethylidenenorbornene (ENB) or dicyclopentadiene (DCPD) in ethylene-propylene-diene (EPDM)...
D6865 Standard Classification System and Basis for Specifications for Acrylonitrile#x2013;Styrene#x2013;Acrylate (ASA) and Acrylonitrile#x2013;EPDM#x2013;Styrene (AES) Plastics and Alloys Molding and Extrusion Materials has been revised to D6865-17
-
Abstract This specification covers acrylonitrile-styrene-acrylate (ASA) and acrylonitrile-EPDM-styrene (AES) plastics and alloys suitable for injection molding and...
D6383/D6383M Standard Practice for Time-to-Failure (Creep-Rupture) of Adhesive Joints Fabricated from EPDM Roof Membrane Material has been reapproved, available as D6383/D6383M-99(2015)
-
Significance and Use 5.1 An important factor affecting the performance of seams of EPDM membranes is their ability to remain bonded over the membrane's expected service...
D6047 Standard Test Methods for Rubber, Raw#x2014;Determination of 5-Ethylidenenorbornene (ENB) or Dicyclopentadiene (DCPD) in Ethylene-Propylene-Diene (EPDM) Terpolymers has been revised to D6047-15
-
Abstract These test methods cover the determination of the content of 5-ethylidenenorbornene (ENB) or dicyclopentadiene (DCPD) in ethylene-propylene-diene (EPDM)...
D4637/D4637M Standard Specification for EPDM Sheet Used In Single-Ply Roof Membrane has been revised to D4637/D4637M-15
-
1. Scope 1.1 This specification covers flexible sheet made from ethylene-propylene-diene terpolymer (EPDM) intended for use in single-ply roofing membranes exposed...
D3900 Standard Test Methods for Rubber#x2014;Determination of Ethylene Units in Ethylene-Propylene Copolymers (EPM) and in Ethylene-Propylene-Diene Terpolymers (EPDM) by Infrared Spectrometry has been revised to D3900-15
-
Significance and Use 4.1 These test methods can be used for determining which EPDM polymers are evaluated in the different compounds in Test Methods D3568. ...
D7465/D7465M Standard Specification for Ethylene Propylene Diene Terpolymer (EPDM) Sheet Used In Geomembrane Applications has been editorially changed, available as D7465/D7465M-15e1
-
1. Scope 1.1 This specification covers flexible sheet made from ethylene propylene diene terpolymer (EPDM) geomembrane intended for use in geotechnical and...
D6369 Standard Guide for Design of Standard Flashing Details for EPDM Roof Membranes (Withdrawn 2015) has been withdrawn, with no replacement. D6369-99(2006)
-
Withdrawn Rationale: This guide covered the design of details for typical conditions encountered in new ballasted, mechanically attached or fully adhered ethylene propylene...
D7106/D7106M Standard Guide for Selection of Test Methods for Ethylene Propylene Diene Terpolymer (EPDM) Geomembranes has been editorially changed, available as D7106/D7106M-05(2015)e1
-
Significance and Use 4.1 This standard provides guidance to obtain data that is the most representative of the material’s characteristics and performance. To...
D7465/D7465M Standard Specification for Ethylene Propylene Diene Terpolymer (EPDM) Sheet Used In Geomembrane Applications has been revised to D7465/D7465M-15
-
1. Scope 1.1 This specification covers flexible sheet made from ethylene propylene diene terpolymer (EPDM) geomembrane intended for use in geotechnical and...
D6047 Standard Test Methods for Rubber, Rawmdash;Determination of 5-Ethylidenenorbornene #40;ENB#41; or Dicyclopentadiene #40;DCPD#41; in Ethylene-Propylene-Diene #40;EPDM#41; Terpolymers has been reapproved, available as D6047-99(2014)
-
Abstract These test methods cover the determination of the content of 5-ethylidenenorbornene (ENB) or dicyclopentadiene (DCPD) in ethylene-propylene-diene (EPDM)...
ISO 4097:2014 - Rubber, ethylene-propylene-diene (EPDM) -- Evaluation procedure
22/09/2014 -
Abstract ISO 4097:2014 specifies physical and chemical tests on raw rubbers; standard materials, standard test formulations, equipment, and processing methods for evaluating the vulcanization...
D4637/D4637M Standard Specification for EPDM Sheet Used In Single-Ply Roof Membrane has been editorially changed, available as D4637/D4637M-14e1
-
1. Scope 1.1 This specification covers flexible sheet made from ethylene-propylene-diene terpolymer (EPDM) intended for use in single-ply roofing membranes exposed...
D4637/D4637M Standard Specification for EPDM Sheet Used In Single-Ply Roof Membrane has been revised to D4637/D4637M-14
-
1. Scope 1.1 This specification covers flexible sheet made from ethylene-propylene-diene terpolymer (EPDM) intended for use in single-ply roofing membranes exposed...
ISO/DIS 4097 - Rubber, ethylene-propylene-diene (EPDM) -- Evaluation procedure
-
Rubber, ethylene-propylene-diene (EPDM) -- Evaluation procedure JavaScript disabled! Please enable JavaScript in your web browser!
ISO 16565:2013 - Rubber -- Determination of 5-ethylidenenorbornene (ENB) or dicyclopentadiene (DCPD) in ethylene-propylene-diene (EPDM) terpolymers
14/05/2013 -
ISO 16565:2013 specifies the methods to be used to determine the content of 5 ethylidenenorbornene (ENB) or dicyclopentadiene (DCPD) in ethylene-propylene-diene (EPDM) terpolymers in the 0,1...
D4637/D4637M Standard Specification for EPDM Sheet Used In Single-Ply Roof Membrane has been revised to D4637/D4637M-13
-
1. Scope 1.1 This specification covers flexible sheet made from ethylene-propylene-diene terpolymer (EPDM) intended for use in single-ply roofing...
