Materiales

 

Materiales

ISO 4641:2024 - Rubber hoses and hose assemblies for water suction and discharge — Specification
- This document specifies the minimum requirements for textile-reinforced, smooth-bore rubber water-suction and discharge hoses and hose assemblies.Three types of hoses and hose assemblies...
ISO 5600:2024 - Rubber — Determination of adhesion to rigid materials using conical shaped parts
- This document specifies a method for the determination of the static vulcanized adhesion strength of rubber compounds to rigid materials. The test piece is composed of two conical ends of the...
ISO 17717:2024 - Meteorological balloons — Specification
- This document specifies the minimum requirements and the test methods for meteorological balloons made from natural rubber latex or natural rubber latex compounded with synthetic rubber...
ISO 5603:2024 - Rubber, vulcanized — Determination of adhesion to wire cord
- This document specifies two methods for determining the adhesion strength of vulcanized rubber to wire cord which is embedded in the rubber.The two methods do not necessarily give the...
ISO/ASTM 52927:2024 - Additive manufacturing — General principles — Main characteristics and corresponding test methods
- This document specifies the principal requirements applied to the testing of parts produced by additive manufacturing processes.This document—     identifies quality...
ISO 10928:2024 - Plastics piping systems — Glass-reinforced thermosetting plastics (GRP) pipes and fittings — Methods for regression analysis and their use
- This document specifies procedures suitable for the analysis of data which, when converted into logarithms of the values, have either a normal or a skewed distribution. It is intended for use...
ISO/TS 22298:2024 - Nanotechnologies — Silica nanomaterials — Specification of characteristics and measurement methods for silica with ordered nanopore array (SONA)
- This document specifies the characteristics of samples of silica with ordered nanopore array (SONA) to be measured in powder form and the industrially available measurement methods used to...
ISO/TS 23927:2024 - Laminates and moulding compounds — Prepregs — Determination of tack
- This document specifies the test method for determining the tack in prepregs under defined conditions.This document is applicable to but not limited to unidirectional and...
ISO 7681:2024 - Natural rubber field latex — Determination of dry rubber content
- This document specifies a method for the determination of the dry rubber content of natural rubber field latex. The method is not suitable for latices from natural sources other than Hevea...
ISO 3384-1:2024 - Rubber, vulcanized or thermoplastic — Determination of stress relaxation in compression — Part 1: Testing at constant temperature
- This document specifies two procedures for determining the decrease in counterforce exerted by a test piece of vulcanized or thermoplastic rubber which has been compressed to a constant...
ISO 16620-4:2024 - Plastics — Biobased content — Part 4: Determination of biobased mass content
- This document specifies a method of determining the biobased mass content in plastics products, based on the radiocarbon analysis and elemental analysis.This document is applicable to...