Otros
Otros
Dynamic Mechanical Properties and Constitutive Model of SiC/Al Considering High Strain Rate and High/Low Temperatures
08/07/2025 -
1) Conduct Hopkinson bar tests on SiC/Al composites at both high and low temperatures under high strain rates. 2) Perform a detailed study of SiC/Al flow characteristics using experimental data. 3)...
Optimizing Microstructure and Performance of Friction Stir Processed Cu–W Composites: The Impact of Predeformation and Traverse Speed
08/07/2025 -
Cu–W composites fabricated using copper rolled sheets exhibit superior uniformity compared to those produced from annealed sheets. The highest strength and toughness are observed in composites...
Direct Laser Writing of Polymer Nanocomposites for Tunable Structural Color
09/07/2025 -
Herein, direct laser writing is used to polymerize self‐assembled nanocomposite materials. Using fabrication parameters, the interparticle spacing is finely tuned beyond the thermodynamically...
Nanoporous Hydrogels with Tunable Pore Size for Efficient Hydrovoltaic Electricity Generation
09/07/2025 -
Nanoporous hydrogels with tunable pore sizes ranging from 78 to 161 nm are developed using a hydrogen‐bonding crosslinking strategy. The structural integrity of the hydrogel nanochannels under...
Initiating Strain Field for Mitigating Lead Leakage in Perovskite Solar Cells with Built‐in Encapsulating Networks
09/07/2025 -
This work demonstrates that chemical sealing networks and strain field regulation enhance the stability of perovskite film and inhibit Pb leakage, achieving a 96.98% suppression of Pb leakage. The...
Accompanying Structural Transformations in Polarity Switching of Heavily Doped Conjugated Polymers
09/07/2025 -
The polarity switching of heavily doped p‐type conjugated polymers (CPs) toward environmentally stable electron‐rich thin films is demonstrated. Multiscale analyses, incorporating spectroscopic,...
Biomimetic Mineralization Nucleation with Polymer Template Enabled High‐Performance Perovskite Solar Cells by Anti‐Solvent‐Free Technology
07/07/2025 -
Anti‐solvent‐free preparation craft of perovskite is expected to promote its scale‐up production, however, the poor nucleation in this process constrains the quality of perovskite films. Here,...
A Tri‐Mode Photothermal, Phase‐Change, and Radiative‐Cooling Film for All‐Day Thermoelectric Generation
07/07/2025 -
Microencapsulated phase change materials (MPCMs) with Ti2O3/TiO2 composite shells are designed for LSPR modulation. MPCMs have full‐spectrum absorption, high photothermal conversion efficiency, and...
Towards Differentiation in Untethered Microactuators: A Soft Fabrication Strategy
07/07/2025 -
This article introduces a fabrication strategy for developing soft microactuators with orthogonally programmed shape, texture, and molecular anisotropy. Using microfluidics to generate liquid crystal...
Lipid Nanocarriers of Naringin Dispersed Gel for Topical Application: Development, In Vitro, Ex Vivo, and In Vivo Kinetics Evaluations
08/07/2025 -
Preration and evaluation of Naringin‐nanosructured lipid carrier.ABSTRACTNanostructured lipid carriers (NLCs) have emerged as promising systems for topical drug delivery due to their enhanced...
High‐Conversion Microreactor for Hydrogenation of Organic Waste
08/07/2025 -
In this research, a highly efficient and stable catalytic layer loaded with palladium nanoparticles was successfully prepared in a microchannel reactor by layer‐by‐layer self‐assembly and ion...
Rare‐Earth Ion Intercalation in Graphene via Thermal and Electrostatic Control
06/07/2025 -
Europium ions reversibly intercalate into the van der Waals gap of bilayer graphene when heat and electrostatic gate act together, switching the stacking order and electronic response on demand....
Dual‐Channel Förster Resonance Energy Transfer Boosting Exciton Utilization Efficiency for High‐Performance Layer‐by‐Layer Processed All‐Small‐Molecule Organic Solar Cells
06/07/2025 -
Benefiting from the combined advantages of the LbL deposition strategy and dual‐channel FRET, a broader spatial distribution of exciton generation sites is achieved, accompanied by significantly...
Development of 3D Reversible Smart Energy‐Saving Devices for Adaptive Energy Management
06/07/2025 -
Smart energy‐saving devices with 3D structures operate passively and exhibit reversible solar heating and radiative cooling functions. These devices demonstrate superior performance in building...
Quasi-ordered plasmonic metasurfaces with unclonable stochastic scattering for secure authentication
08/07/2025 -
Integrating solar and wind energy with battery storage systems into microgrids is gaining prominence in both remote areas and high-rise urban buildings. Optimally designing all distributed energy...
Hierarchically MOF‐Based Porous Monolith Composites for Atmospheric Water Harvesting
02/07/2025 -
This review explores the design of hierarchical porous materials for atmospheric water harvesting, focusing on metal‐organic frameworks (MOFs) and porous monoliths. Emphasis is placed on...
Dual‐Amide Engineered Blue Phase Liquid Crystal Elastomers: Synergistic Fatigue Resistance, Programmable Mechanochromics and Spatiotemporally Encrypted Photonics
01/07/2025 -
Dual‐amide engineering creates a hierarchical energy dissipation system in blue phase liquid crystal elastomers, yielding remarkable toughness and ultralow hysteresis. This strategy enables...
Use of CsPbCl3 Quantum Dots as a Chlorine Source Enables Formation of Thick Quasi‐2D Perovskite Films for High‐Performance Blue Light Emitting Diodes
01/07/2025 -
The use of organic‐inorganic hybrid chlorine sources allows the preparation of thick perovskite films, leading to sky‐blue light‐emitting diodes (LEDs) with a record‐high external quantum...
Porous Elastomer Film with Controlled Liquid‐Metal Distribution for Recyclable Highly Customizable and Stretchable Patterned Electronics
01/07/2025 -
This study presents a customizable porous liquid‐metal (LM)/elastomer composite film with controlled LM distribution, overcoming conventional limitations of LM‐based composites (unintended...
Curing reaction kinetics of paper-based phenolic resin laminates—from laboratory measurements to inline quality control
-
We describe a comprehensive analysis of the drying and curing kinetics of resol phenol–formaldehyde (PF) resin utilizing multiple different thermophysical and optical measurement techniques and...
Assessing food by-products macrocomposition by FTIR microspectroscopy
-
Food by-products offer a promising opportunity for extracting valuable compounds that can be used in the food, pharmaceutical, and polymer industries. However, unpredictable variations in the...