Eléctrico
Eléctrico
Aerospace, Vol. 10, Pages 516: Experimental Evaluation of Vibrational Stability of SOPs in Aerospace Industry Using PCB Strain Effectiveness of a PCB-Strain-Based Design Methodology
30/05/2023 -
Steinberg’s theory, which is based on the fatigue failure theory, has been widely used for predicting the structural safety of solder joints in aerospace electronic units under vibration during...
Ultrathin CNTs Film Based on Marangoni Effect for Strain Sensing Application
01/06/2023 -
The Marangoni effect has been applied in the preparation of large-area ultrathin films. However, defects occur frequently during the transfer progress of ultrathin films to substrates, which limits...
The Design and Development of Woven Textile Solar Panels
01/06/2023 -
Over the past few years, alternative power supplies to either supplement or replace batteries for electronic textile and wearable applications have been sought, with the development of wearable solar...
Effect of Sintering Mechanism towards Crystallization of Geopolymer Ceramic—A Review
31/05/2023 -
Globally, there is an increasing need for ceramic materials that have a variety of applications in the environment, for precision tools, and for the biomedical, electronics, and environmental...
Metal Contact Induced Unconventional Field Effect in Metallic Carbon Nanotubes
31/05/2023 -
One-dimensional carbon nanotubes (CNTs) are promising for future nanoelectronics and optoelectronics, and an understanding of electrical contacts is essential for developing these technologies....
High Performance On-Chip Energy Storage Capacitors with Plasma-Enhanced Atomic Layer-Deposited Hf0.5Zr0.5O2/Al-Doped Hf0.25Zr0.75O2 Nanofilms as Dielectrics
30/05/2023 -
Concurrently achieving high energy storage density (ESD) and efficiency has always been a big challenge for electrostatic energy storage capacitors. In this study, we successfully fabricate...
Three-Dimensional Printable Flexible Piezoelectric Composites with Energy Harvesting Features
31/05/2023 -
The purpose of this work was to obtain an elastic composite material from polymer powders (polyurethane and polypropylene) with the addition of BaTiO3 until 35% with tailored dielectric and...
Novel SMD Component and Module Interconnection and Encapsulation Technique for Textile Substrates Using 3D Printed Polymer Materials
30/05/2023 -
Nowadays, a range of sensors and actuators can be realized directly in the structure of textile substrates using metal-plated yarns, metal-filament yarns, or functionalized yarns with nanomaterials,...
Indium Recycling from Waste Liquid Crystal Displays: Is It Possible?
30/05/2023 -
The utilization of valuable properties of waste and their reuse as raw materials is an imperative of the circular economy. Waste electrical and electronic equipment (WEEE) is a significant source of...
Superconductivity, Charge Density Wave, and Supersolidity in Flat Bands with a Tunable Quantum Metric
-
Predicting the fate of an interacting system in the limit where the electronic bandwidth is quenched is often highly nontrivial. The complex interplay between interactions and quantum fluctuations...
Ultrafast Switching from the Charge Density Wave Phase to a Metastable Metallic State in $1Ttext{?}{mathrm{TiSe}}_{2}$
-
The ultrafast electronic structures of the charge density wave material 1T?TiSe2 were investigated by high-resolution time- and angle-resolved photoemission spectroscopy. We found that the...
Changes in Japanese physicians’ relationships with the pharmaceutical industry between 2008 and 2021: A national survey
01/06/2023 -
AbstractBackground
Synergistic dispersion and tribo?film formation of liquid metal @graphene oxide/epoxy coating: Toward improved mechanical and anti?wear properties
30/05/2023 -
Diagram of liquid metal @ graphene oxide/epoxy coating with better mechanical and anti?wear properties.A series of epoxy composite coatings filled with liquid metal (LM) and graphene oxide (GO) are...
Paper?based Printed Antenna: Investigation of Process?induced and Climatic?induced Performance Variability
26/05/2023 -
Printing technologies have emerged as a viable method for the fabrication of various electronic components, including sensors, actuators, energy harvesters, thin?film transistors and circuits, as...
Effect of pH on Structure, Optical, and Dielectric Properties of BaTiO3 Nanoparticles
28/05/2023 -
Barium titanate nanoparticles are prepared with varying pH values from 9 to 12 via hydrothermal method. The initial precursors are considered to be Ba(NO3)2 and TiO2. Stainless?steel autoclave having...
Determination of Irreversible Deformation for Numerical Prediction of Functional Processes of Geotechnical Nonwoven Materials
25/05/2023 -
Gelation in polyacrylonitrile fiber precursor during spinning from a polymer solution was examined. One of the assumptions during the study was that gelation was examined only as a diffusion...
Aerospace, Vol. 10, Pages 503: Interplanetary Student Nanospacecraft: Development of the LEO Demonstrator ESTCube-2
26/05/2023 -
Nanosatellites have established their importance in low-Earth orbit (LEO), and it is common for student teams to build them for educational and technology demonstration purposes. The next challenge...
State Residualisation and Kron Reduction for Model Order Reduction of Energy Systems
29/05/2023 -
Greater numbers of power electronics (PEs) converters are being connected to energy systems due to the development of renewable energy sources, high-voltage transmission, and PE-interfaced loads....
Wide-Range-Sensing Candle Soot/Elastomer Strain Sensors with High Sensitivity
29/05/2023 -
Nowadays, flexible resistive strain sensors attract growing attention owing to their various applications in the fields of electronic skin, human health detection, body motion, etc. Unfortunately, to...
Immunomodulatory and Antioxidant Effects of Spray-Dried Encapsulated Kale Sprouts after In Vitro Gastrointestinal Digestion
26/05/2023 -
The health-related compounds present in kale are vulnerable to the digestive process or storage conditions. Encapsulation has become an alternative for their protection and takes advantage of their...
UV-Activated Au Modified TiO2/In2O3 Hollow Nanospheres for Formaldehyde Detection at Room Temperature
26/05/2023 -
Au modified TiO2/In2O3 hollow nanospheres were synthesized by the hydrolysis method using the carbon nanospheres as a sacrificial template. Compared to pure In2O3, pure TiO2, and TiO2/In2O3 based...