Otros
Otros
D2240 Standard Test Method for Rubber Propertyâ??Durometer Hardness has been reapproved, available as D2240-15(2021)
-
Significance and Use 4.1Â This test method is based on the penetration of a specific type of indentor when forced into the material under specified conditions. The indentation...
ISO 48-9:2018 - Rubber, vulcanized or thermoplastic -- Determination of hardness -- Part 9: Calibration and verification of hardness testers
-
This document specifies procedures for the calibration and verification of durometers of types A, D, AO and AM (see ISO 48-4), IRHD pocket meters (see ISO 48-5), IRHD dead-load instruments (see...
ISO 48-4:2018 - Rubber, vulcanized or thermoplastic -- Determination of hardness -- Part 4: Indentation hardness by durometer method (Shore hardness)
-
This document specifies a method for determining the indentation hardness (Shore hardness) of vulcanized or thermoplastic rubber using durometers with the following scales:— ...
ISO 48-7:2018 - Rubber, vulcanized or thermoplastic -- Determination of hardness -- Part 7: Apparent hardness of rubber-covered rollers by Shore-type durometer method
-
This document specifies a method for the determination of the apparent hardness of vulcanized- or thermoplastic-rubber roller covers, expressed in Shore hardness, for measurement where only...
ISO 18898:2016 - Rubber -- Calibration and verification of hardness testers
17/02/2016 -
Abstract ISO 18898:2016 specifies procedures for the calibration and verification of durometers of types A, D, AO and AM (see ISO 7619?1), IRHD pocket meters (see ISO 7619?2), IRHD dead-load...
D2240 Standard Test Method for Rubber Property#x2014;Durometer Hardness has been revised to D2240-15
-
Significance and Use 4.1 This test method is based on the penetration of a specific type of indentor when forced into the material under specified conditions. The...
C661 Standard Test Method for Indentation Hardness of Elastomeric-Type Sealants by Means of a Durometer has been revised to C661-15
-
Significance and Use 4.1 The results obtained by this test method are simply a measure of the indentation into the sealant material of the indentor under load; they are...
ISO 7267-2:2008 - Rubber-covered rollers -- Determination of apparent hardness -- Part 2: Shore-type durometer method
22/06/2011 -
Abstract ISO 7267-2:2008 specifies a method for the determination of the apparent hardness of vulcanized- or thermoplastic-rubber roller covers, expressed in Shore hardness, for measurement...
